Custom corners to mount a glass bed to the A350. Should fit flush with your glass bed.
This is a general design, and you may need to adjust the sides to come in slightly closer depending on your glass bed.
You may also need to adjust the height so it is flush with the top of your glass bed. This is for a 3.8mm high bed that is just slightly (0.5mm) larger than the Snapmaker bed in all dimensions.
Make sure to only adjust inner walls and not outer walls, as adjusting outer walls may cause them to run in to the Z axis rails.
One M4 10mm bolt is required per corner piece
| Back_Left.stl | 930.6KB | |
| Back_Right.stl | 1.2MB | |
| Front_Left.stl | 785.8KB | |
| Front_Right.stl | 1.1MB |
