Tired of digging for your deer bleat can when sitting in your stand? Tired of dropping the can when you have that Monster standing there while you grab your bow? This is the product for you!
This is v1 so you will need to put a piece of tape over the hole for the can to operate correctly when you turn it. V2, when I get around to designing it, will plug the hole for you and will also clamp onto the stand instead of just hanging.
You will need on M4 Socket head bolt 15mm or so long, Nylock M4 nut and a flat washer.
I printed in PLA, but I don't plan on leaving it out at my stand for extended periods of time, though I don't think it would really effect anything.
| Holder_v0-1.stl | 55.6KB | |
| Mount_v0-1.stl | 44.4KB |
