A French Cleat is a method of holding tools by pairing two 45 degree angles together. A lot of people use Pegboards for the same purpose but many of us prefer the French Cleat design instead as it can hold significantly more weight.
With so many great tool holder designs available for Pegboard on Thingiverse I decided to make it easier to use some of these designs on my French Cleats by pairing them together.
Since some tools can weigh quite a bit, I included moveable pegs that go on the back side to provide support.
For the pegboard I used: https://www.thingiverse.com/thing:2145069
You can connect additional pegboards with this: https://www.thingiverse.com/thing:2145096
The safety goggle adapter pictured: https://www.thingiverse.com/thing:1741176
The Tool Loop pictured: https://www.thingiverse.com/thing:272552
| French_Cleat_to_Peg_3_Holes.stl | 54.8KB | |
| French_Cleat_to_Peg_4_Holes.stl | 75.0KB | |
| French_Cleat_to_Peg_5_Holes.stl | 90.0KB | |
| French_Cleat_to_Peg_6_Holes.stl | 107.5KB | |
| Support_Peg_-_Long.stl | 35.8KB | |
| Support_Peg_-_Short.stl | 35.7KB |
