This is my selfmade hookah. It is nearly fully printable, you only have to buy the hookah pot, the rubber for the hookah pot, the plate and some tubes.
It is about 550mm high when it`s assembled.
You only have to glue the tube adapters. The other parts you can screw together.
The threads are at first a little bit stiff, you have to screw them a few times, then they go smoothly.
Edit: I optimized the threads with bottle threads, now they now screw together smoothly.
Also I added new Tube Adapters, to hold the tubes without falling off while smoking.
| Hookah_bowl.STL | 6.0MB | |
| Hookah_headadapter.STL | 1.7MB | |
| Hookah_Midsection.STL | 8.1MB | |
| Hookah_Steampipe.STL | 3.1MB | |
| Hookah_Tubeadapter_1.STL | 1.1MB | |
| Hookah_Tubeadapter_2.STL | 2.6MB | |
| Hookah_Tubeadapter_optional.STL | 2.8MB |
