A locking cover for the Lay Flat Ethernet Spool by Howey3323. For when the pieces of that spool don't click together because there's too much wiggle room, which was the case when I printed it.
Fits (very) snug into the middle of the spool, locking both parts together. Make sure the top few layers are printed with a low layer height (.2 or lower), to make sure the locking edge comes out right. It might take a little bit of force to get it in there, but that's exactly the point!
| Ethernet_Spool_Locking_Cover.stl | 388.7KB |
