The files for a small 1.5mm drill made with a DVD drive motor.
all DVD drive motors have a very similar size so it should work well for pretty much all of them. the adapter is a tight fit so no glue is required and the motor is glued/taped to the handle (I used some tape to center the motor to the handle when gluing).
In the pictures the power is provided by an old charger (I used a 12v 2.5A laptop charger). The more powerful the charger the more power the motor has but overpowering it will result in damage over time. If it seems unsafe to you don't do it.
I just cut the tip off, striped the wires and connected them to the motor making sure that the drill bit is rotating the right way.
Please do your own research and use safety equipment when building and using this device. I am not responsible for any harm or damage that may be caused.
| adapter.stl | 15.7KB | |
| handle.stl | 106.2KB |
