So, this is the model of the Madison (Built 1887) or her sister ship the Alna. Provided is the only photo of her.
Use the parts that don't have "PRE 1890s" in them for, guess what, a boat that is not pre 1890s. However, for a pre-1890s version, use all the normal parts exept the deck, which should be the "PRE 1890s" version and print two of the "PRE 1890s" smoke stacks. you will still need a stove exhaust pipe (either the normal one or the fancy one), as it was originally used for a woodstove.
The smoke stack(s) fits into the hole on the deck, but the rest is up to you on placement since its a generic small steam boat from the period. There are 4 paddle wheels included, so make sure you get the one you need (Print two if its a half):
PADDLE FULL - for if you're doing resin and are putting it permanently in water on your layout
PADDLE CUT - for if you're doing resin but want it movable/aren't doing resin water
PADDLE HALF - for if you're doing PLA and putting it permanently in water on your layout
PADDLE HALF CUT - for if you're doing PLA but want it movable/aren't doing resin water
PS, the stack is hollow, so if you don't glue the deck down, you can put a smoke machine in there or a block of dry ice and as long as you have plastic on the windows, the stack will smoke!!!!!!
also all the madison stuff is for madison, indiana not madison, wisconsen
| The_Madison_CRANE.stl | 12.7KB | |
| The_Madison_DECK.stl | 32.1KB | |
| The_Madison_DECK_PRE_1890s.stl | 55.6KB | |
| The_Madison_EXAUST.stl | 7.9KB | |
| The_Madison_EXAUST_FANCY.stl | 40.0KB | |
| The_Madison_GANWAY.stl | 2.2KB | |
| The_Madison_MAIN.stl | 568.3KB | |
| The_Madison_PADDLE_CUT.stl | 165.5KB | |
| The_Madison_PADDLE_FULL.stl | 185.0KB | |
| The_Madison_PADDLE_HALF.stl | 107.7KB | |
| The_Madison_PADDLE_HALF_CUT.stl | 106.1KB | |
| The_Madison_PRE_1890s_SMOKE_STACK.stl | 423.7KB | |
| The_Madison_WHEELHOUSE.stl | 408.5KB |
