Neck mod/peg for Sentinel SV-Action Miles Morales. Can't afford the one from FigureFix (since I'm UK) so made one myself after waiting ages for my figure to arrive.
I haven't tried this with FDM so experiment at your own risk. Might work better if you 'flatten' the peg?
If you're using resin, USE SIRAYA TECH BLU or similar, otherwise you are going to have a broken peg stuck in your neck. You've been warned!
For those who do not have BLU or Tenacious to mix with, print off your peg and cast them. I did this and it works very well. I used blue stuff as the mould, and used green stuff as the casting material. I put some aluminium wire in the middle (you can use a staple) and it's strong enough to pull out and grips heads very well. It works well without the wire as well but it has some flex to it.
Has a slight gapage (if that's a word) at the back but it isn't too bad. Allows the head to till up a bit up. On the unmasked head, the peg is better titled forward and there is hardly any gap. Again, allows a bit more head tilting upwards.
If you need help/advice on the mould/cast step or have feedback, send me a message on reddit. I'm /u/nobo13.
| must-use-sirayatech-BLU.stl | 471.9KB |
