Hightower: A 3D-Printable Vertical Mini-ITX PC Chassis
This is a Mini-ITX case in the style of the Xbox Series One, the Phanteks Evolv Shift, or the NZXT H1: it has a small footprint, but plenty of space inside.
This is designed to be printable on a Prusa i3 MK3S, so your printer needs a print volume of at least 250 x 210 x 210 mm. Please look at the printing settings for more information on how to best print the parts.
This is not a good model for 3D printing beginners to start out with, as it requires specific settings for specific parts, and has some parts that are difficult to print.
Supports a two-slot graphics card with essentially no length limit.
Please look at the pictures of the assembled case, and read the 3D printing settings section for assembly instructions.
The assembled case is approximately 240mm wide, 210mm deep, and 520mm tall.
| fan_cover_base.stl | 157.9KB | |
| fan_cover_base_and_top.stl | 869.1KB | |
| frontpanel_bottom_section.stl | 2.9MB | |
| frontpanel_top_section.stl | 3.0MB | |
| mini_itx_small_vertical_chassis.scad | 32.2KB | |
| rubber_foot_4x.stl | 1.4MB | |
| section_base.stl | 2.3MB | |
| section_base_cable_gasket.stl | 356.3KB | |
| section_base_cable_gasket_open.stl | 332.2KB | |
| section_motherboard-v2.stl | 1.4MB | |
| section_power_supply.stl | 3.1MB | |
| section_top_flat.stl | 2.2MB | |
| section_top_rounded.stl | 3.5MB | |
| section_top_rounded_square_vent_holes.stl | 5.5MB | |
| top_fan_holder.stl | 1.1MB | |
| top_fan_holder_square_vent_holes.stl | 2.0MB |
