This is meant to attach just above your kitchenaid refrigerator's filtered water dispenser. In addition to the 3d printed parts, you'll need 2 M5x16 cap-head screws.
Printed flat-ish in PETG. PLA should also work. Ideally, you'd actually print both pieces on their side to make the hinges as strong as possible, but mine worked anyway.
Here are the steps for assembly:
BONUS STEP: You want to get it so the lever just barely activates the button when it's pressed all the way down. You may need to add a little bit of tape to the lever where it touches the button to dial-in the tolerances for your refrigerator.
| DispenserBase.stl | 83.1KB | |
| DispenserLever.stl | 122.6KB | |
| WaterDispenser_v0.f3d | 1008.7KB |
