Reductor that done from identical gears 1:4 each (uniform) and can be setup with as many gears in sequence as you need (scalable) to get ratio and torque that you need.
On images reductor done from 4 gears and has ration 1:256, but you can easy install more/less gears to each of two reductor axes to have ratio that you need.
There also included fram for gears system with holder for motor.
| Gear_10-to-40.SLDASM | 256.0KB | |
| Gear_10-to-40.STL | 211.8KB | |
| Metric_-_Spur_gear_2M_10T_20PA_12FW_---S10N75H50L4N.sldprt | 746.0KB | |
| Metric_-_Spur_gear_2M_10T_20PA_12FW_---S10N75H50L4N.STL | 47.3KB | |
| Metric_-_Spur_gear_2M_12T_20PA_12FW_---S12N75H50L5N.sldprt | 738.5KB | |
| Metric_-_Spur_gear_2M_12T_20PA_12FW_---S12N75H50L5N.STL | 43.4KB | |
| Motor_Gear_Connector_Sliced_-_2.SLDPRT | 325.5KB | |
| Motor_Gear_Connector_Sliced_-_2.STL | 32.9KB | |
| Motor_Holder_Bottom.SLDPRT | 198.5KB | |
| Motor_Holder_Bottom.STL | 25.9KB | |
| Motor_Holder_Opposite.SLDPRT | 535.0KB | |
| Motor_Holder_Opposite.STL | 96.7KB | |
| Motor_Holder_Rail.SLDPRT | 309.5KB | |
| Motor_Holder_Rail_37_mm.STL | 117.7KB | |
| Motor_Holder_Rail_7_mm.STL | 52.1KB | |
| Motor_Holder_Top.SLDPRT | 689.5KB | |
| Motor_Holder_Top.STL | 135.4KB |
