WORK IN PROGRESS
V5 is now almost complete with back plate and all the mouting hardware for it, just having it tested after last modifications. .
WARNING - check Your fit before You squeeze the parts in, I already broke his fist of Silverbolt trying to take the thigh out.
The corrected model has now been uploaded, printed on my zortrax it slides in and out with little tension, still - make sure it will do the same on Your printer. in case it gets stuck there are holes in front in case you need to push the leg out.
I've also mirrored the thigh so that You can make a pair straight away. I'm just having it printed so will report how it went.
second project in progress - a heavy modification for CW Superion
will consist of
so far i have a rough design of the thigh extenders, they still need some work - especially getting the dimentions right - they can snap in solid if printed too tght so as always i advise cution before trying them on. or even better - measuring them and the figure to make sure they will not jam once installed.
more things to follow.
stay tuned!
| v05pt1corrected_back_L.stl | 215.1KB | |
| v05pt1corrected_back_R.stl | 203.1KB | |
| v05pt1corrected_back_to_front_connector_L.stl | 737.2KB | |
| v05pt1corrected_back_to_front_connector_R.stl | 745.3KB | |
| v05pt1corrected_grill_L.stl | 120.6KB | |
| v05pt1corrected_grill_R.stl | 119.4KB | |
| v05pt1corrected_L.stl | 1.3MB | |
| v05pt1corrected_R.stl | 1.3MB | |
| v5_pin_connector.stl | 77.0KB |
