This is a Toy Chest at a 1:12 scale. It has a sliding lid for half of the chest, and it has two drawers for the other half. Print the Toy Box Frame with supports to ensure the drawer rails and the drawer openings print properly. Depending on the resolution of your printer, you may need to resize the drawers slightly. Put the sliding lid on the side of the box opposite the drawers. Glue the top to the chest at the four corners, taking care to not get any glue on the sliding lid. None of the other parts need supports.
I did not print with supports, and the flaws you see on the side are where the inside rails meet the sides. Supports would have eliminated that issue.
This model was adapted from Woodsmith Issue 29.
| Toy_Box_Frame_1-12_Scale.stl | 145.2KB | |
| Toy_Box_Lower_Drawer_1-12_Scale.stl | 14.3KB | |
| Toy_Box_Sliding_Lid_1-12_scale.stl | 2.0KB | |
| Toy_Box_Top_1-12_Scale.stl | 9.5KB | |
| Toy_Box_Upper_Drawer_1-12_Scale.stl | 14.3KB |
