The Abandoned Windmill 3D Printer Model
The file 'The Abandoned Windmill 3D Printer Model' is (stl) file type, size is 60.6MB.
The file 'The Abandoned Windmill 3D Printer Model' is (stl) file type, size is 60.6MB.
Here is the Abandoned Windmill. It is a motorized Windmill that sits atop The Abandoned Lighthouse, designed by Ecaroth https://www.thingiverse.com/thing:3706122
You will need to print The Abandoned Lighthouse first. I used a low rpm motor inside the windmill. This is the motor I used: https://www.amazon.com/gp/product/B07QTQ4QN9/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1
Once you have printed the Lighthouse and Windmill, you can attach the motor to the motor holder using two small bolts with nuts. Place the motor holder in the slot in the windmill body. Glue the Windmill blades to the Blade Hub. Glue the Blade Hub to the Center Motor Pin. Insert the whole blade assembly through the hole in the front of the windmill body and over the motor pin. Use a small piece of wire or a cut toothpick to secure the Center Motor Pin to the motor pin. Thread the wires down through the lighthouse sections. Wire up the motor to a lamp cord with a plug using some small wire nuts. Plug it in and watch it go!
Enjoy!
| Windmill_Blade_Broken1.stl | 7.7MB | |
| Windmill_Blade_Broken2.stl | 6.9MB | |
| Windmill_Blade_Broken3.stl | 7.3MB | |
| Windmill_Blade_Hub.stl | 4.0MB | |
| Windmill_Blade_Whole.stl | 8.4MB | |
| Windmill_Body.stl | 52.0MB | |
| Windmill_Center_Motor_Pin.stl | 1.4MB | |
| Windmill_Motor_Holder.stl | 29.8KB | |
| Windmill_Roof.stl | 32.1MB |
