Heavy Duty Safe-door with locking system.
You can endlessly spin the handwheel until you unlock with the key. The key only locks at one position of the inner mechanic.
it should be complicated to hack the door, for somebody who does not know the mechanism and if you count the spins of the handwheel after locking, no thief remains without traces.
The door is saved with six 7mm bolts, it stays secured even if the hinge will be destroyed.
you can print the Frame with 120mm container, or the frame for glueing on or screwing from behind
Some parts with joinings are available in two versions, for bolts of 1.75mm or 3mm. use a scrap of filament to join them. I recommend 3mm filament
To install the door-hinge and to assemble the handwheel you need CA glue.
for assembly sequence check the pictures.
brake all edges of the parts after printing and make sure, that all sliding planes are clean and smooth.
Have fun and don´t lose the key :D
| 120mm_Box.STL | 1.6MB | |
| Bolzen_175mm.STL | 1.2MB | |
| Bolzen_3mm.STL | 1.2MB | |
| Buchse.STL | 219.0KB | |
| Gehaeuse.STL | 7.2MB | |
| Gehaeuse_Deckel.STL | 6.5MB | |
| Griff.STL | 743.2KB | |
| Knauf-Pin.STL | 1.8MB | |
| Knauf_Basis.STL | 1.5MB | |
| Nabe_175mm.STL | 545.8KB | |
| Nabe_3mm.STL | 545.9KB | |
| Nabe_Deckel_175mm.STL | 658.1KB | |
| Nabe_Deckel_3mm.STL | 659.1KB | |
| Nocke.STL | 221.0KB | |
| Planetenrad.STL | 238.3KB | |
| Pleuel_175mm.STL | 135.8KB | |
| Pleuel_3mm.STL | 135.8KB | |
| Rahmen.STL | 992.0KB | |
| Scharnier1.STL | 349.5KB | |
| Scharnier2.STL | 133.9KB | |
| Scharnier_Bolzen.STL | 115.7KB | |
| Scharnier_Bolzen_Kappe.STL | 96.6KB | |
| Schlüssel.STL | 34.1MB | |
| Sharnier_Gelenk.STL | 207.7KB | |
| Sonnenrad.STL | 290.1KB | |
| Sperrad.STL | 212.4KB | |
| Sperrklinke.STL | 61.6KB |
