There's a huge lack of Ramadan decorations out there so my wife and I designed this one based off some ideas we found online. We printed the flags of the banner out of a nice matte PLA and the overlay letters out of just plain black PLA. Any colors possible though!
One thing I will say is these are pretty thick and use a lot of filament so you might want to cut the thickness in half from the bottom. That and the hanging holes were really tiny, I'd definitely make those bigger or expect to drill them out. If there's enough interest, I'll make the mods myself and reupload.
We ran out of the overlay light brown we were using and unfortunately the B and K don't match. We will reprint those once the new roll gets in.
| A-Flag.stl | 3.4MB | |
| A-overlay.stl | 80.4KB | |
| B-Flag.stl | 3.3MB | |
| B-overlay.stl | 119.4KB | |
| D-Flag.stl | 3.3MB | |
| D-overlay.stl | 74.3KB | |
| K-Flag.stl | 3.4MB | |
| K-overlay.stl | 117.8KB | |
| M-Flag.stl | 3.3MB | |
| M-overlay.stl | 96.1KB | |
| N-Flag.stl | 3.4MB | |
| N-overlay.stl | 78.2KB | |
| R-Flag.stl | 3.3MB | |
| R-overlay.stl | 112.5KB | |
| U-Flag.stl | 3.4MB | |
| U-overlay.stl | 108.7KB |
