Pool Cue Rack 3D Printer Model
The file 'Pool Cue Rack 3D Printer Model' is (stl,scad) file type, size is 12.2KB.
The file 'Pool Cue Rack 3D Printer Model' is (stl,scad) file type, size is 12.2KB.
This design is for parts to build a pool cue rack. The holder is flexible to allow a cue to be snap locked onto the rack. There is also a base that can be used to hold the bottom end of the cue.
Each holder is screwed onto a (typically a 1x2) board using two 1/2 inch #4 (wood or sheet metal) screws. Each base should be secured onto a (typically 3 inch wide) board using one 3/4 inch #4 wood screw.
A Jig is also provided to simplify spacing/placement of the holes when building a rack. You may want to change some of the dimensions in the OpenSCAD file. The recommended spacing is 2 inches from the center of each cue.
The OpenSCAD file is provided to allow for customizations.
| CueBase.stl | 22.2KB | |
| CueHolder.stl | 22.9KB | |
| CueHolderJig.stl | 8.3KB | |
| Cue_Holder.scad | 1.4KB |
