Fully Printed 1:28 RC Car Chassis (MINI-Z Compatible) 3D Printer Model
The file 'Fully Printed 1:28 RC Car Chassis (MINI-Z Compatible) 3D Printer Model' is (stl,skp) file type, size is 1.6MB.
The file 'Fully Printed 1:28 RC Car Chassis (MINI-Z Compatible) 3D Printer Model' is (stl,skp) file type, size is 1.6MB.
| Part | Quantity | Notes |
|---|---|---|
| M3x20mm button head screw | 7 | |
| M3x14mm button head screw | 2 | |
| M3x10mm button head screw | 8 | |
| M3 lock nut | 17 | |
| 625 bearing | 4 | |
| 130 size brushed motor, 2s compatible | 1 | |
| SG90 micro servo | 1 | |
| Compression spring, ~4mm OD, ~6mm length | 2 | For front suspension. Softer springs are better. Retractable pen springs cut to ~6mm can work, but are a bit stiff. |
| Compression spring, ~4mm OD, ~20mm length | 2 | For rear suspension. Uncut retractable pen springs work for this. |
| Venom Fly 300mah 2s battery (JST connector) | 1 | Batteries up to 45x23x16mm should fit |
| Small brushed ESC, 2S compatible | 1 | |
| Small radio receiver | 1 | 2 channels or more, smaller than approx 34x22x13mm. Flysky GR3E works if decased. |
| tray1.stl | 331.2KB | |
| tray2.stl | 951.1KB | |
| zcar.skp | 3.3MB | |
| zcar.stl | 1.5MB |
