Fishing Rod Holder (Storage Rack) 3D Printer Model
The file 'Fishing Rod Holder (Storage Rack) 3D Printer Model' is (stl) file type, size is 27.3KB.
The file 'Fishing Rod Holder (Storage Rack) 3D Printer Model' is (stl) file type, size is 27.3KB.
This fishing rod holder can be mounted on a wall or ceiling or boat at any angle. The STL file includes 2 mirrored parts which together make one rod-holder capable of storing 4 fishing rods. This model is 270mm wide and will not fit on smaller beds.
The three horizontal holes are for mounting. The 2 vertical holes are for shock-cord. The shock cord is not needed but I would recommend for use in a boat. To use, feed one piece of shock-cord through both holes and tie off so they won't pull back through. Then use the rod tip to push the shock cord back towards the rear or up (depending on how it was mounted). Once the rod-tip is in place the shock-cord will apply pressure to keep the tip in one of the notches.
| Rod_Holder_v1.stl | 136.0KB |
