A smaller version of my other latch, has a softer snap action and is generally smaller.
Print in place, no supports needed.
Update 14/01/2021:
Removed some material from the female side clip, it is now a little more snappy without being too strong.
Update 05/02/2021:
Please orientate the part so it prints flat on the print bed, this is important as it plays to the strength on printer layers instead of against them.
| Extremely_Weak_Clamp_Female_Side_Only.stl | 360.8KB | |
| Female_catch_only_re-upload_due_to_failure.stl | 250.6KB | |
| Male_Pin_Only.stl | 147.8KB | |
| Right_Angle.stl | 323.9KB | |
| Right_Angle_Extremely_Weak_Clamp_Female_Side_Only.stl | 450.0KB | |
| Right_Angle_Male_Pin_Only.stl | 213.4KB | |
| Version_2_Complete.stl | 398.3KB | |
| Weaker_Clip_Female_Side_Only.stl | 252.7KB |
