Cross-stitch IPhone SE Case, Outer Shell 3D Printer Model
The file 'Cross-stitch IPhone SE Case, Outer Shell 3D Printer Model' is (scad,stl) file type, size is 926.7KB.
The file 'Cross-stitch IPhone SE Case, Outer Shell 3D Printer Model' is (scad,stl) file type, size is 926.7KB.
An iPhone SE/5S/5 case that you can cross-stitch any design onto.
I remixed this outer shell case by cutting a grid of square holes in it with OpenSCAD, then exporting a new STL file.
Some of the square holes closed up a bit more than I liked. So after the print finished, I went back and drilled all the holes out with a 1/16-inch bit, then deburred them with a 1/2-inch countersink. I also sanded down the rough surfaces on the inside of the case.
| cx_phone_v7.scad | 1.4KB | |
| cx_phone_v7.stl | 9.4MB |
