I found this catcher by "basti_vapes" but want to seperate the plate and the catcher,
so the Plate can be turned in all 6 directions.
The Catcher was printed upside-down.
The open side, where the marble goes in, was placed on the bed.
The ring is printed separately (upside down) and glued into the plate bottom.
The upper part of the catcher tend to tip out of the plate, when the marbles hit the back wall of the catcher.
Therfore the plate got a groove around all 6 sides, and the catcher got a bulge at the side where the marbles goes in.
The bulge of the catcher fit into the groove of the plate and the catcher doesn't tip over so easily
The second version of the catcher is a test for easier printing.
| Catcher_Platte_01.stl | 1.3MB | |
| Catcher_Platte_01.stp | 345.6KB | |
| Catcher_Trichter_01.stl | 1.7MB | |
| Catcher_Trichter_01.stp | 194.1KB | |
| Catcher_Trichter_02.stl | 1.7MB | |
| Catcher_Trichter_02.stp | 195.1KB | |
| Ring.stl | 1.2MB | |
| Ring_stronger.stl | 1.2MB |
