I made this to go in my Crescent Tools 31 Piece VORTEX™ Bit Holder Fastening Set case. I hated how much wasted space there was in there and figured this would be much denser. Holds 50 1/4" bits.
I ordered 5x2mm magnets off of Amazon and glued them into the bottom of every single hole using Gorilla Glue clear two part epoxy.
To install this you have to pop out the orange inner piece by prying it out at the top or bottom, slide this guy in, then pop it back into the case.
May or may not fit in other crescent bit cases, not sure.
Perhaps one day i'll remember to take a picture of it when I go to work, for now all you get is the original set off of google lol
| Corrected_and_Improved_Bit_Holder.stl | 142.5KB |
