Chinese, oriental style bird feeder. My own original design, but feel free to remix as you please. There are 2x roof sizes to suit different size 3D printer build plates. You don't need to print both. Only the roof file needs minimal support inside the locating squares underneath. the rest of the files can be printed without any supports. Obviously rotate the files to fit them flat onto the build plate. The Lattice sides will need gluing to the 4 posts of the main body. Be careful to get the correct lattice sides onto the main body as they are subtly different in height and width. You will need to print 2 of each type. Lay them out to check they are the right way round before committing to gluing. Once glued, the lattice box then just slots onto the base... and the roof onto the lattice box. I used a bit of blu tack to hold them in place. You could glue the main lattice box onto the base if you preferred but the roof needs to remain removable so you can refill with bird food. Finally the Dragons (Print x2) needs to be glued on to the roof. Then, hey presto! your done.
| Latice_Roof_Dragon_1.stl | 2.3MB | |
| Latice_Side_1_NEW.stl | 57.2KB | |
| Latice_Side_2_NEW.stl | 51.7KB | |
| Lattice_Base_XX.stl | 11.5KB | |
| Lattice_Bigger_Roof_XX.stl | 2.3MB | |
| Lattice_Legs_new_XXX.stl | 19.3MB | |
| Lattice_Smaller_ROOF_XXX.stl | 2.3MB |
