**Update (6/23/2018): I'm sharing this Fusion 360 model(I hope I did it right): https://a360.co/2KgA3Z9
I'm sorry to anyone who has tried to contact me. I've been busy with a full-time job plus engineering classes. Every time I log in, I see that I have infinity notifications waiting for me to address them.
But, I finally took the time to figure out how to share the model so you can make changes or fix the model in any way you want.
I'm glad so many people have gotten use out of my design.
**Update (7/24/2017): Important notes in the print settings.
I've been debating mounting a TV on the ceiling above my bed. The only reason I haven't done it is because of a fear of being crushed by a falling TV while I'm sleeping.
This design allows me to watch Youtube, Netflix, or other streaming video while I'm falling asleep.
Non-Printed Parts:
Adhesive Metal Plate for Magnetic Phone Mounts
4-Pack Enkay 4480-C Magnets
4x Screws that fit in a 5 mm hole with a head diameter no larger than 7.9 mm
4x Wall Anchors for those screws
Electrical Tape
If I had to guess on the screw size based on the charts I found online, I would say it's a #10 screw, but I designed the wall mount around some unlabeled screws and anchors I had lying around.
| Arm_-_Threaded.stl | 687.6KB | |
| Arm_-_Unthreaded.stl | 1.1MB | |
| Knob.stl | 1.4MB | |
| Mag_Mount_-_Cap.stl | 1.1MB | |
| Mag_Mount_-_Magnet_Holder.stl | 1.0MB | |
| Short_Arm_-_Threaded.stl | 5.7MB | |
| Short_Arm_-_Unthreaded.stl | 1.1MB | |
| Wall_Mount.stl | 394.4KB | |
| Wall_Mount_-_Arm_requires_support.stl | 886.7KB | |
| Wall_Mount_-_Bolt.stl | 697.6KB | |
| Wall_Mount_-_Nut.stl | 1.6MB |
