I couldn't find a stand for these 5L apple juice bags and wanted to have them on the table to easily put a glass below for filling.
Take a look into the print notes below! I tried to minimize supports and brim but some are still needed.
The stand does not cover the full bag size because I wanted to print it with my K1C.
Therefore you need a print bed size of at least 215mmx215mm
The two top parts can be pushed together (no glue needed) and the rods can be screwed in on the top and bottom part at the same time (Threads have different directions).
Edit: I added a drip tray.
| Base.stl | 377.9KB | |
| Drip.stl | 476.9KB | |
| LeftPartTop.stl | 193.6KB | |
| RightPartTop.stl | 193.6KB | |
| Rod_print_4_times.stl | 198.0KB |
