I have some HID pod lights that I have recently installed in my 1998 Jeep Wrangler TJ. My Jeep was a factory soft top, meaning there are no switches or a wiring harness to control accessories on a hard top. To make my cheap switches look like a more "professional" job, I made 3 of these to replace the solid dummy ones that I would otherwise cut in the radio/dash bezel. They are a tight fit and look very similar to the factory ones when printed in black. I used 3 2-position rocker switches that have the 3 terminals on the back for female wire connectors. I do no know if they fit any other model Jeep because I made these to custom fit mine. They require no glue, fasteners, or attachment methods other than the clips on the switch and the retaining hooks on the 3d printed pieces.
Edit: 2021-1-11: Added blank .stl and .obj versions of dummy switch without hole.
| Jeep_Dummy_Switch.stl | 447.2KB | |
| Jeep_Dummy_Switch_Blank.obj | 323.8KB | |
| Jeep_Dummy_Switch_Blank.stl | 441.4KB |
