These electrocarts where used widely from the late 1950s until the 1990s for transporting luggage, post and parcels on railway-stations in Germany. Italy, and the Benelux-countries. The manufacturer also exported some vehicles to Japan.
Some examples were also used in the industry.
The model is drawn for 1-gauge (1/32). The pictures shows a model printed in 1/32.
For LGB it can be printed enlarged with factor 1.5. This will give a scale of
1/21.3 but can be used with 3mm axles. If the model is printed with another
scale-factor the axles and rims must be drilled according to the size of the
axles.
The model is printed in usual PLA. The tires are printed in TPU. All parts are
printed with support “touch build plate only”. The front-axle is printed lying
flat, the rear-axle upside-down with the springs on the build plate.
The handrails beside the seats should be glued to the chassis.
Note that the rims for the front- and rear axle are different.
The front axle should be inserted turned 45° to side. It self-locks in
horizontal position.
| body.stl |
| front-axle.stl |
| grip.stl |
| rear-axle.stl |
| rim-front.stl |
| rim-rear.stl |
| steering.stl |
| tire.stl |
| total_do_not_print.stl |
