The file 'Long Wide Walkway 20×8 Cm With Supports For 3mm Laser Cut MDF' is (ai,cdr,dxf,pdf) file type, size is 2.2MB.
This is a walkway which is part of my Necromunda collection. It was designed to be cut from 4mm material and the files have been converted to 3mm. Pictures are of the original.
To make one walkway, print one floor plate and four supports.
When assembling the supports, glue the vertical sides together first, then add the bottom and top pieces. For the floor plate, just glue the sides and bottom piece together.
The walkway attaches to wide connection points at either end, such as the ones on this structure:
https://www.thingiverse.com/thing:2898783
It also has one narrow connection point on either side, where you can attach narrow walkways from my walkway connection:
https://www.thingiverse.com/Bilbostomper/collections/walkway-collection
or one of my narrow staircases:
https://www.thingiverse.com/thing:2868451
https://www.thingiverse.com/thing:2870065
or one of the narrow guard rail pieces:
https://www.thingiverse.com/thing:2915692
or this ladder:
https://www.thingiverse.com/thing:2882460
Dimensions are roughly 22x9x12 cm (XYZ)
Black = cut
Red = engrave
Note: You can make a 2 level walkway if you print two floor plates and use the supports from this structure instead:
https://www.thingiverse.com/thing:2886710
| support_short_3mm.ai | 957.4KB | |
| support_short_3mm.cdr | 409.9KB | |
| support_short_3mm.dxf | 278.6KB | |
| support_short_3mm.pdf | 387.0KB | |
| walkway_20x8_1_3mm.ai | 71.7KB | |
| walkway_20x8_1_3mm.cdr | 455.6KB | |
| walkway_20x8_1_3mm.dxf | 898.8KB | |
| walkway_20x8_1_3mm.pdf | 399.0KB |
