I have this problem when some of the zippers on my jeans will slowly unzip and I will be walking around with the "barn door" open. Originally I was using the life hack of a key ring to keep the zipper up, but with a 3d printer I thought I could make something more "fun".
So here it is. It's not quite 100% but it gets the job done. Areas for improvement are that it could be better matched to the zipper pull to prevent it from coming off in the dryer, it could be thinner, and there might be some different button configurations it needs to loop around.
If you experience a similar problem to mine, then this will give you a fix.
| zipper_stay.stl | 60.9KB |
