Zigzag Fall For Gravitrax V2 – Vertical Version 3D Printer Model
The file 'Zigzag Fall For Gravitrax V2 – Vertical Version 3D Printer Model' is (stl) file type, size is 1.2MB.
The file 'Zigzag Fall For Gravitrax V2 – Vertical Version 3D Printer Model' is (stl) file type, size is 1.2MB.
This set is designed to create an easy-to-assemble zigzag course and get a good visibility of passing balls.
The design has been simplified compared to the previous version, featuring a more visibility for passing balls and the use of different rings.
(previous ver. : https://www.printables.com/model/989118-vertical-spiral-zigzag-modules-for-gravitrax)
Please set the rails parallel to each other.
The ball falls 20mm vertically.
I think you might also want tunnel tiles, especially for the bottom layer… please use the tunnel tiles I've uploaded separately or try using my "Spider Spacers".
Tunnel Tiles : https://www.printables.com/model/1032076-tunnel-tiles-for-gravitrax-v2
Spider Spacers : https://www.printables.com/model/1033087-spider-spacers-for-gravitrax
Also, a complementary spiral drop version is also available for added versatility.
https://www.printables.com/model/1032051-zigzag-fall-for-gravitrax-v2-spiral-version
Note : Please refer to the attached photo for the printing instructions. Support is essential for the upper and lower ring parts. I set the support angle to around 75 degrees and used support blockers to avoid unnecessary support for other parts.
| base.stl | 1.5MB | |
| ring_v1.01_normal.stl | 133.2KB | |
| upper.stl | 1.4MB |
