Zelda Twilight Princess Fused Shadow V4 (LARGE) 3D Printer Model Free Download

Description Files (18)

Summary

A new revised version of the twilight princess helmet model after trying to print a large version and finding some minor faults that needed correcting (straightened nose, missing grooves, overlapping vertices). Easier to upload a new version than to change the old one. 0.2 mm gap between parts only. Model 'fixed' on 3D Builder for your convenience.

See older v3 post for more detail about origins.

This version stands about 1 m tall when fully assembled and was sized at 730% scale of the 14cm small version to take full advantage of a printer with a 40cm^3 print bed volume. Smaller printers will require scaling however this will also reduce the gap between cracked parts so caution is advised. Files for mount included, intended for use with a hat stand pole+base. I used about 12kg of filament during construction, but that did include a few miss-prints.

I have not included the gcode files because your printer may vary, but also because this was my first time adding supports to something like this so I suspect it could be done better.

Bot-Back_New_-_fix.stl	28.1MB
Bot-Back_Part1_New.stl	21.4MB
Bot-Back_Part2_New.stl	17.3MB
Bot-Front_New_-_fix.stl	44.3MB
Bot-Front_Part1_New.stl	26.8MB
Bot-Front_Part2_New.stl	32.7MB
Helmet_whole_730_scale.stl	89.9MB
Helmet_whole_730_scale_-_inner_mold_99_373mm_-_37.2mm_pole_hole_v2.stl	12.4MB
Helmet_whole_730_scale_-_inner_mould.stl	1.3MB
Top-Back_New_-_fix.stl	20.2MB
Top-Back_part1_v1_half-split_right.stl	10.3MB
Top-Back_part1_v2_split_left_two-third.stl	12.3MB
Top-Back_part2_v1_half-split_left.stl	10.4MB
Top-Back_part2_v2_split_right_one-third.stl	8.1MB
Top-Front_New_-_fix.stl	64.0MB
Top-Front_part1_New.stl	41.4MB
Top-Front_part2_New.stl	28.0MB
Top-Front_part3_New.stl	23.2MB

Zelda Twilight Princess Fused Shadow V4 (LARGE) 3D Printer Model

Summary

Tags

You might also like