Summary
The wonderful YF-22 ATFHQ model by Joh76, scaled and sliced for 200mm x 200mm x 200mm printers such as the Ultimaker. This model is scaled at 50% of the original, and is still nearly three feet long when fully assembled. I also designed a stand that works with 1/2 inch PVC fittings for displaying this beast.
Instructions
PLEASE print all of your parts with some degree of fill (about 17% recommended), this model has internal structures that curl if there is no fill, causing prints to fail. Other than that, print the stand (f22_stand.stl) at greater than 33% fill, it has a lot of strain put on it by the weight of the model. As far as putting all of the pieces together, I plastic-welded mine together using a soldering gun. I recommend this method for filling in the gaps between pieces caused by curling, it is a must if you want a clean-looking end product.
| Aile_arriere_droite_YF-22.stl | 108.1KB | |
| Aile_arriere_gauche_YF-22.stl | 110.4KB | |
| f-22_left_tail1.stl | 248.7KB | |
| f-22_left_tail2.stl | 2.0MB | |
| f-22_left_tail3.stl | 1.7MB | |
| f-22_left_tail4.stl | 1.1MB | |
| f-22_left_wing1.stl | 1.5MB | |
| f-22_left_wing2.stl | 489.6KB | |
| f-22_left_wing3.5.stl | 1.1MB | |
| f-22_left_wing3.stl | 1.2MB | |
| f-22_left_wing4.stl | 942.8KB | |
| f-22_nose1.stl | 604.0KB | |
| f-22_nose2.stl | 1.9MB | |
| f-22_nose_left1.stl | 3.2MB | |
| f-22_nose_left2.stl | 976.9KB | |
| f-22_nose_right1.stl | 3.2MB | |
| f-22_nose_right2.stl | 4.9MB | |
| f-22_raptor_2.fabbproject | 2.2MB | |
| f-22_right_tail1.stl | 385.4KB | |
| f-22_right_tail2.stl | 976.4KB | |
| f-22_right_tail3.stl | 1.8MB | |
| f-22_right_tail4.stl | 888.0KB | |
| f-22_right_wing1.stl | 8.5MB | |
| f-22_right_wing2.stl | 448.9KB | |
| f-22_right_wing3.5.stl | 923.3KB | |
| f-22_right_wing3.stl | 1.1MB | |
| f-22_right_wing4.stl | 961.1KB | |
| F22_STAND.stl | 1.4MB |
