The original case by Kilinich is a great idea!
But my DSO138 clone from ZC did not fit well.
The PCBis only 1mm thick, the slide switches did not protude enough and the buttons were too hard to press.
.
The case was tweaked until it fitted better. The snap-in brackets were replaced by a PCB support frame for easier removal.
I supplied a step-file for for your own customisation.
| case.3mf | 183.5KB | |
| case.stl | 709.7KB | |
| case_cover.3mf | 22.8KB | |
| case_cover.stl | 78.1KB | |
| DSO138_Oscilloscope_Cover2_v7.step | 10.0MB | |
| PCBFixing.3mf | 2.6KB | |
| PCBFixing.stl | 5.4KB |
