Replacement Impeller for Yawn airbeds (Original impeller appears to have a common fault where it falls to bits).
Specifically the 'YAWN Self Inflating Double Air Bed Deluxe' but might fit others, tried and tested on a faulty shop returned unit. Faff to open the motor itself but works a treat.
Will need a 2 part epoxy for sufficient adhesion to the motor shaft!
Printed in PLA, mine needed a bit of post-processing as my retraction was off but should be fine if your printer is dialled in properly.
At max quality the teeth on the through hole for the shaft might actually grip well enough to not need glue but i've not tested that!
| Yawn_Impeller.STL | 206.7KB |
