These are auxilary fittings for the "XY Flexure Translation Stage" for a Retro-Reflector in an Michelson Interferometer.

Thex XY Flexure Translation Stage is printed with 70mm width.
You need to print:

• XY Translation Flexure Stage : 70mm width (scaling 58%)
• 2 x Clamp
• 2 x Magnet-Clamp
• 1 x XY-Flexure-Mount
  (Flexurefix is a spare blade which can be used if blades are not or insufficiently printed)
• 1 x L-Holder

In addition following parts are needed:

• 2 x M3 screw, steel, length:40mm
• 2 x Nd Magnet 4 mm diameter
• 2 x Steel balls 4mm diameter
• 2 x hex distance rods with 3mm thread. 4.8mm width
• 2 x M4 screws, steel, length:10mm
• 1 x M3 screw (plastic)
• 1 x M3 nut (plastic)
• 1 x M3 washer (pastic)

Optional:

• if screws are lose you can use teflon tape to increase thread friction
• Actuator Knobs for finer adjustment are prefereable