3D Printer Models

XTool D1 Pro Foot Brackets And Honeycomb Risers 3D Printer Model

Author: @Projectionist

License: CC BY

File formats: stl

Download type: zip

Size:1.9MB

The file 'XTool D1 Pro Foot Brackets And Honeycomb Risers 3D Printer Model' is (stl) file type, size is 1.9MB.

Description Files (6)

Summary

xTool D1 Pro Mounting Kit

I developed this kit to help mount my xTool D1 laser cutter to a sheet of MDF. These parts were designed to work with #8 Truss Head wood screws. The riser corners separate the protective aluminum panel on the bottom from the honeycomb panel above, allowing better airflow when using the air assist kit

Kit Includes:

Foot brackets for the add-on risers (print 4)
- Note that these will not work with the standard D1 feet without at least one set of risers attached
- Remove the rubber bumpers on the bottom of the legs before installing
Riser blocks for the honeycomb work panel
- Separate STLs are provided to accommodate the corner with the rivet
- For a single honeycomb setup, print one rivet riser, and three standard risers
- For a double honeycomb setup, print two rivet risers, two standard risers, and two divider risers
Drill guides are provided if you want help aligning and pre-drilling holes in your mounting board

By lifting the honeycomb panel, there may be a bit of flex if you will be cutting or engraving heavy materials. Consider adding an additional support under the honeycomb if you experience flexing that causes the laser to loose focus. The riser lifts the honeycomb panel 22mm above the aluminum protection panel's surface.

Drill_Guide_-_Corner.stl	525.0KB
Drill_Guide_-_Divider.stl	531.6KB
Honeycomb_Riser.stl	1.1MB
Honeycomb_Riser_-_Divider.stl	799.3KB
Honeycomb_Riser_-_Rivet.stl	1.4MB
xTool_D1-Riser_Foot_Bracket.stl	581.0KB

XTool D1 Pro Foot Brackets And Honeycomb Risers 3D Printer Model

Summary

xTool D1 Pro Mounting Kit

Kit Includes:

Tags

You might also like