XLights Data/Ethernet Cable Snap On Numbering Clips (for Long Range Receivers) 3D Printer Model
The file 'XLights Data/Ethernet Cable Snap On Numbering Clips (for Long Range Receivers) 3D Printer Model' is (stl) file type, size is 547.0KB.
The file 'XLights Data/Ethernet Cable Snap On Numbering Clips (for Long Range Receivers) 3D Printer Model' is (stl) file type, size is 547.0KB.
NOTE: Print one first to check fit for your RJ45 cables. Cables from different companies are different sizes so you may have to adjust. I added 10% for some receivers I built that have fatter cables.
These are snap-on RJ45 cable labels for pixel controller and receiver cables. Each clip has numbers for the receivers 17-20, 21-24, 25-28, 29-32, 33-36, 37-40, 41-44 & 45-48 through 48 and have A-F for receiver chains. There are also IN & OUT labels for the ethernet cables.
Print a set of 2 of the same numbers (i.e. 17-21 for the first long range receiver). Snap one on the the RJ45 cable on the controller and the other on the corresponding receiver RJ45 cable. There are also single A-F labels for receiver chains.
Enjoy!!
| RcvEth-IN.stl | 54.4KB | |
| RcvEth-OUT.stl | 124.0KB | |
| RcvEth17-20.stl | 173.9KB | |
| RcvEth21-24.stl | 151.8KB | |
| RcvEth25-28.stl | 248.6KB | |
| RcvEth29-32.stl | 256.1KB | |
| RcvEth33-36.stl | 304.3KB | |
| RcvEth37-40.stl | 184.4KB | |
| RcvEth41-44.stl | 84.2KB | |
| RcvEth45-48.stl | 181.1KB | |
| RcvEthA.stl | 44.4KB | |
| RcvEthB.stl | 81.3KB | |
| RcvEthC.stl | 76.2KB | |
| RcvEthD.stl | 72.2KB | |
| RcvEthE.stl | 39.3KB | |
| RcvEthF.stl | 38.9KB |
