XL And L Fursuit Batteries 3D Printer Model
The file 'XL And L Fursuit Batteries 3D Printer Model' is (stl) file type, size is 3.9MB.
The file 'XL And L Fursuit Batteries 3D Printer Model' is (stl) file type, size is 3.9MB.
This is a large battery case meant for powering a Protogen head but can also be used for other fursuit power. it should be bolted or riveted to a waistbelt and transmit power through a coil cord up to the head.
It is set up for 12 18650 cells in a 3s configuration. The 2 ports on the side are for a 16mm rocker switch and 16mm 4 pin aviator connector for charging. The rectangular side hole is for a small voltage display.
2 decorative variants with stars and radioactive
There is also a smaller version here that only contains 6 cells that was used for void protogen if you'd prefer that.
| BatteryBase.stl | 1.8MB | |
| BatteryBaseStar.stl | 5.9MB | |
| BatteryBaseTrefoil.stl | 2.1MB | |
| BatteryCap.stl | 649.5KB | |
| BattPackcase.stl | 208.5KB | |
| BattPackCaseFinal.stl | 332.8KB | |
| BattPackLid.stl | 210.0KB |
