The XGimi Halo is designed to be located below the screen it is projecting on.
The point is that I put mine above our bedhead, so it must be tilted.
This model offers a plate with a basic angle, plus a screw allowing to raise it at the perfect angle.
Note that a M10x1 thread has been chosen to have a precise adjustment.
A 0.2mm gap between the thread of the plate and the thread of the screw has already been set up.
Last but not least, a 1/4 inch screw is added to maintain the projector in place.
I plan to add some kind of rubber feet, but I haven't found them yet.
Cheers!
| 1_quarter_inch_screw.stl | 1.7MB | |
| M10x1_feet.stl | 3.5MB | |
| Plate.stl | 632.0KB |
