UPDATE 4/11 I ADDED PLAYSTATION AND SWITCH LOGO STLs FOR BOTH LONG AND SHORT VERSIONS!!
Xbox bookend for keeping Xbox games organized. There are two versions. The long version, like the one in the pictures, opens to about 330mm. It holds the games pictured and can hold a few more than that. The other version is a shorter and opens to about 150mm.
The bookend will print in two parts; left and right bookend that simply slide into each other. Each part of the long version is 183mm long x 100mm wide x 90mm tall. The short version parts are about 90mm long x 100mm wide x 90 mm tall.
The right bookend was printed with supports for the slide part and the extruded controller/xbox logo. The left bookend prints with supports only for the extruded controller/xbox logo.
Once printed, you will need to remove supports. They came off pretty easy on the bottom of the rails on the right bookend. The controller/xbox logo can be removed fairly easy as well.
I printed the bookend at 0.2 mm layer height.
| PS_Bookend_Left_Long.stl | 710.9KB | |
| PS_Bookend_Left_Short.stl | 761.0KB | |
| PS_Bookend_Right_Long.stl | 743.1KB | |
| PS_Bookend_Right_Short.stl | 775.4KB | |
| Switch_Bookend_Left_Long.stl | 506.2KB | |
| Switch_Bookend_Right_Long.stl | 543.0KB | |
| Switch_Bookend_Right_Short.stl | 565.0KB | |
| Switch_Left_Bookend_Short.stl | 546.3KB | |
| Xbox_Bookend_Left_Long.stl | 1.2MB | |
| Xbox_Bookend_Left_Short.stl | 1.4MB | |
| Xbox_Bookend_Right_Long.stl | 1.3MB | |
| Xbox_Right_Bookend_Short.stl | 1.4MB |
