X20 Team Battery Recover 3D Printer Model
The file 'X20 Team Battery Recover 3D Printer Model' is (stl) file type, size is 431.3KB.
The file 'X20 Team Battery Recover 3D Printer Model' is (stl) file type, size is 431.3KB.
Recover a drain x20 battery (the charger wont give charge if the voltage is too low and start blinking the two leds )
by boost it with a parallel connection with a full charge battery for a while the voltage on the low voltage battery recover fast.
sometimes i do this manually just with wires but is not practical and there's a risk of short circuit.
PROCEDURE:
connect the a full and the drain battery's , keep the parallel connection for 30seconds to one minute max.
remove the drain battery
wait a few minutes to battery cool down
put to charge again
and the charger accepts the battery now
need :
four long faston 6.3 male terminals or similar
piece of wire
connect + with + and - with - ( PARALLEL)
hot glue to secure it inside
glue the lid
| x20_Booster.stl | 1.0MB |
