X-Men Quicksilver Stereobelt 3D Printer Model
The file 'X-Men Quicksilver Stereobelt 3D Printer Model' is (stl,zip) file type, size is 1.1MB.
The file 'X-Men Quicksilver Stereobelt 3D Printer Model' is (stl,zip) file type, size is 1.1MB.
I've had a bit of an obsession with Quicksilver's audio gear from X-Men: Days of Future Past (see my article here: http://www.tested.com/art/movies/461631-x-men-tale-portable-tape/) and a friend went as Quicksilver for NYC Comic Con, so I made a Stereobelt for her. These are the primary units to make your own Stereobelt as well as a printable cassette (although a real one will fit too).
I have complete Stereobelt kits, Battery Pack Add-ons, movie-accurate versions of the stickers printed on polyester and 1/4" headphone plugs available on my Etsy store: https://charlesworthdynamics.etsy.com
| case_bolt_x4.stl | 11.2KB | |
| connection_pin_x13.stl | 684.0B | |
| LT_cap_back.stl | 26.1KB | |
| LT_case_bottom.stl | 51.0KB | |
| LT_case_top.stl | 114.8KB | |
| LT_case_trim.stl | 73.5KB | |
| LT_front_panel_1.stl | 3.6KB | |
| LT_front_panel_2.stl | 9.5KB | |
| RT_cap_back.stl | 26.3KB | |
| RT_cap_front.stl | 123.4KB | |
| RT_case_bottom.stl | 25.6KB | |
| RT_case_top.stl | 343.8KB | |
| RT_case_trim.stl | 68.8KB | |
| RT_front_panel_1.stl | 40.3KB | |
| RT_front_panel_2.stl | 29.6KB | |
| RT_knob_plate.stl | 94.8KB | |
| RT_slider_knob_x4.stl | 7.1KB | |
| RT_slider_plate_x4.stl | 35.2KB | |
| RT_stick_plate.stl | 96.4KB | |
| RT_switch_plate.stl | 41.7KB | |
| stereobelt_stickers.zip | 764.8KB | |
| tape_bottom.stl | 32.8KB | |
| tape_top.stl | 462.5KB |
