This is an articulating ball joint arm that can be assembled with several different length sections. The sections can be mixed and matched for the application. The base is designed for aluminum extrusion with T-slots 20mm on center. A small piece of steel was attached with a 3M double sided sticky pad to the top piece. Magnets in the base of the Wyze Cam then hold it in place.
Ball arm and ball cup halves are joined together with threaded rod, cut to 20mm lengths. I also super-glued the two pieces together for a more permanent solution.
| Ball-base_v2_v34_v1.stl | 320.5KB | |
| Ball-bottom_v2_v25.stl | 210.5KB | |
| Ball-cup0_v2_v14.stl | 287.2KB | |
| Ball-cup1_v2_v8.stl | 293.1KB | |
| Ball-cup2_v2_v9.stl | 299.1KB | |
| Ball-cup3_v2_v10.stl | 305.1KB | |
| Ball-nut_v2_v16_v1.stl | 559.7KB | |
| Ball-shaft1_v2_v30.stl | 220.8KB | |
| Ball-shaft2_v2_v30.stl | 304.2KB | |
| Ball-shaft3_v2_v32.stl | 387.6KB | |
| Ball-top_v2_v27.stl | 92.5KB |
