Wyze Cam V3 Tower Mount – Use With Rat Or Mouse Trap 3D Printer Model
The file 'Wyze Cam V3 Tower Mount – Use With Rat Or Mouse Trap 3D Printer Model' is (stl) file type, size is 843.1KB.
The file 'Wyze Cam V3 Tower Mount – Use With Rat Or Mouse Trap 3D Printer Model' is (stl) file type, size is 843.1KB.
This a Wyze camera holder compatible with the Victor Compatible Rat (https://www.thingiverse.com/thing:6611506) and Mouse Trap Hood (https://www.thingiverse.com/thing:6618628). The different sizes allow the Wyze cam to clear the arm bar when it flips up and not hit the camera.
This is designed to use the included screws and washer inside the Wyze v3 camera box. Place the washer on top of the tower, slide the mount on and screw the two screws in. Push back and down lightly on the mount when tightening the screws. The Wyze Camera v3 has a magnet in it and placing the washer there will give it extra support. The mount can be screwed down with three #4 screws. If you are mounting on a wood board with the rat trap, I would recommend a wood board size of 6"x15"-17".
Add a power bank or usb battery adapter to one of your power tool batteries for some portability.
Note: I haven't tested the mouse trap tower size yet and if the mount is compatible with Wyze Cam v4.
Wyze Cam v3 is supported by the fully local open source thingino firmware (https://thingino.com).
Check out the Customizable Rodent Vacuum - https://www.thingiverse.com/thing:6774185. It includes a wall mountable Wyze Camera v3 mount.
| Wyze_Cam_v3_Mount_v1.stl | 98.6KB | |
| Wyze_Cam_v3_Tower_-_Mouse_v1.stl | 1.1MB | |
| Wyze_Cam_v3_Tower_-_Rat_v1.stl | 1.1MB |
