I wanted a camera mount that fit more or less within the printer's footprint and that could see the nozzle area. I was inspired by other camera mounts that attached themselves to the X-gantry.
There are no screws required, it should fit snug on to the plastic cap for the X-axis motor. It will fit the gray base of a Wyze Cam V2 perfectly. Perhaps a little too perfectly, as it might tear off the little rubber feet on the bottom. I really wanted to make sure the camera didn't move or vibrate once mounted. I also included STLs both with cable clips (intended for a flat USB cable) and without cable clips (use zip ties or something for cable management).
I tried to design this to be printed with as few supports as possible, but you will need a few to support the square mount. I used bed only tree supports and it came out just fine.
Enjoy.
| wyze_cam_v2_mount_sv07.stl | 1.2MB | |
| wyze_cam_v2_mount_sv07_no_clips.stl | 1.1MB |
