WurstWerfer Parts For Nirodhas Bullpup 3D Printer Model
The file 'WurstWerfer Parts For Nirodhas Bullpup 3D Printer Model' is (STL) file type, size is 107.5MB.
The file 'WurstWerfer Parts For Nirodhas Bullpup 3D Printer Model' is (STL) file type, size is 107.5MB.
This is my own personal spin on Nirodhas great Bullpup. I tried to make it look a bit more tacticool withouth messing up the og look too much.
The magwell allows you to see how much darts are left in the mag (up to 3 darts left) but to use it...you pretty much have to reprint the whole blaster.
The triggerguard istn part of the shroud anymore, so you will need a few additional 10mm long toyscrews. two for the trigger guard, one for the shroud connector. You also will need a new heatinsert for the connector.
You also have to reprint the top front rail, as i needed to change up the screw spacing alittle bit.
If you print the Backplate with the slingmount in anything else than hardish TPU your Blaster will have a bad time!
| BULLPUP_Barrelshroud_ohne_tg.STL | 38.9MB | |
| BULLPUP_magwell_tacticool.STL | 39.3MB | |
| BULLPUP_Shroudspacer.STL | 2.9MB | |
| Bullpup_stock_cover+34mm.STL | 71.4MB | |
| Bullpup_stock_cover+slingmount.STL | 74.4MB | |
| BULLPUP_top_NATO_rail_font.STL | 1.8MB | |
| BULLPUP_Triggerguard.STL | 26.7MB | |
| Shroud_connector.STL | 988.8KB |
