Hey, this is a mudguard designed for the Woom 1 balance bike. There is none available to buy so I designed it. It helps my daughters back to stay clean while riding her bike and also her longer jackets don't rub on the backwheel anymore while cruising around.
It's printed in two parts that you glue together after printing. Due to the round shape it would need too much supports if printed differently.
The diameter of the hole for the seat post is 22,3mm this makes is a tight fit which then can be pressed perfectly with the added M5 insert and a 35mm long screw.
The angle of the hole is 72°. As long as those fit your balance bike you should be fine to start right away.
| Mudguard_1.stl | 169.1KB | |
| Mudguard_2.stl | 166.4KB |
