UPDATE 15-FEB-2017:
I updated the two base parts to the correct versions with holes for the feet pins. See "WMammoth_Base1_v3.stl" and "WMammoth_Base2_v3.stl".
UPDATE 26-DEC-2016:
I updated the four "feet" models to the correct v3 version. The previous ones were missing the connector pins to snap into the base parts. I also updated the pelvis-spine-skull pins model to be a smaller file size, but you will need to print three of them, hence the "x3" in the file name..
The source file for this model is the 3D scan of a woolly mammoth skeleton from the Smithsonian Institution National Museum of Natural History site at: http://www.3d.si.edu
The scale of the .STL files is 1:10.
I separated the original model into printable pieces and added snap together features to make it easier to assemble. I also added a two-piece to make the assembled model stand properly and improve strength. The model in the pictures did not have snap features so gluing it together was difficult. I have not tested all of the snap fits, so please let me know of any issues if you build it.
The model in the photos was printed at 75% scale to fit the 205mm square bed of my printer. This makes the final scale of the model in the pictures 1:13. The height of the assembled model is approximately 350mm (13.8"), or at the 75% scale to fit most printers the height is approximately 260mm (10.3")..
| WMammoth_Base1_v3.stl | 6.1MB | |
| WMammoth_Base2_v3.stl | 8.5MB | |
| WMammoth_Jaw_v2.stl | 6.6MB | |
| WMammoth_LF_Foot_v3.stl | 7.7MB | |
| WMammoth_LF_Foreleg_v2a.stl | 11.8MB | |
| WMammoth_LR_Foot_v3.stl | 6.2MB | |
| WMammoth_Pelvis_Spine_Skull_Pin_x3.stl | 4.6MB | |
| WMammoth_Pelvis_v2.stl | 12.9MB | |
| WMammoth_RF_Foot_v3.stl | 8.1MB | |
| WMammoth_RF_Foreleg_v2a.stl | 14.3MB | |
| WMammoth_RR_Foot_v3.stl | 6.7MB | |
| WMammoth_Skull_v2.stl | 10.9MB | |
| WMammoth_Spine_Ribcage_Front_v2.stl | 31.4MB | |
| WMammoth_Spine_Ribcage_Rear_v2.stl | 15.7MB | |
| WMammoth_Tail_v2.stl | 3.6MB |
