WOOPECKERZ are an easy one piece print that moves in a pecking action to function as a peg, clip or stand.... or just for fun!

At standard scale Woodpeckerz are 75mm tall. They print on their side with no support required. Raft is recommended. Print with 3 shells or more and at least 50% infill to make them strong and springy. Great printed with PLA. The designed in clearances required to allow movement should work with most well set up accurate 3D printers.

Print a few in your choice of color... Woodpeckerz are fun to have around the house or office as well as being a great novelty gift.

Please refer to the images and print instructions for additional information.

Other similar designs are as follows:

'Z-REX' http://www.thingiverse.com/thing:1594269

'Ratz' http://www.thingiverse.com/thing:1532944

'Sharkz' http://www.thingiverse.com/thing:910216

'Crocz' http://www.thingiverse.com/thing:941177

'Eaglez' http://www.thingiverse.com/thing:963892

'Catz' http://www.thingiverse.com/thing:988088

Note: If you like this check out the rest of my fun and practical designs!

Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!